Quick Setup - TP-Link TL-WA5110G User Manual

If the result displayed is similar to that shown in Figure 3-2, it means that your PC has not
connected to the AP.
Please check the connection following these steps:
1. Is the connection between your PC and the AP correct?
Note:
The LED of LAN port you link to on the AP and LEDs on your PC's adapter should be lit.
2. Is the TCP/IP configuration for your PC correct?
Note:
If the AP's IP address is 192.168.1.1, your PC's IP address must be within the range of
192.168.1.2 ~ 192.168.1.254, the gateway must be 192.168.1.1

3.2. Quick Setup

The following instructions will guide you through a few easy steps to configure your AP and
connect to Internet. With a Web-based (Internet Explorer or Netscape
to configure and manage the TL-WA5110G 54M High Power Wireless Access Point. The
Web-based utility can be used on any Windows, Macintosh or UNIX OS with a Web browser.
Open your web browser and enter the IP address of the AP (192.168.1.1), and a login screen will
display(shown in Figure 3-3).
Enter admin for Username and Password(both in lower case letters) on the following login screen.
Click OK or press Enter of your keyboard, and the management page will display.
Figure 3-1 Success result of Ping command
Figure 3-2 Failure result of Ping command
Figure 3-3 Login the router
8
®
Navigator) utility, it is easy