Quick Setup; Wps - TP-Link AP300 User Manual

Chapter 4
4. 1.

Quick Setup

Quick Setup wizard allows you to quickly configure your AP device step by step. Choose
the suitable operation mode according to your network environment and follow the
step-by-step instructions.
1. Visit http://tplinkap.net, and log in with the username and password you set for the
AP device.
2. Go to Quick Setup
configure your AP device.
4. 2.

WPS

WPS (Wi-Fi Protected Setup) feature can help you to quickly and securely connect to
a network. WPS functions differently in different operation modes. In Access Point and
Multi-SSID modes, the WPS feature can be used only when the network security is set
to None or WPA2-PSK/AES. In Repeater/Bridge and Client modes, this device can use
WPS (Push button method) to connect to Host network while local wireless networks
do not support the WPS feature.
This section will guide you to add a new wireless device to an existing network quickly
by the WPS feature. There are two ways to use this feature: by push button method and
by PIN (Personal Identification Number). The PIN method can only be applied in Access
Point and Multi-SSID modes.
Push Button Method
Follow the steps below to use WPS by push button method.
1. Press the WPS button on the real panel of the AP device. The WPS LED will blink slowly,
which shows the function has been triggered and the device is trying to connect or
to be conected. This process may take up to 2 minutes.
on the top of the page, and follow the on-screen instrustions to
14