Fisher & Paykel ACTIVESMART RS36W80 Series Installation Manual page 39

[B] FIXED SCREW METHOD — METHOD TO USE IF CABINET IS NOT TO SPECIFICATION
(Attempt method [A]. If method [A] results in poor fitment of side trims due to cabinetry that is uneven or out of specification, use method [B]).
Internal box
Break off the datum lip to each side trim
1
bracket and discard.
Cabinet side
D
Repeat for all side trim brackets.
trim install kit
Side trim bracket
(6)
Spring clip
(6)
External box
For 80" (2032mm) cavity installation only
Cabinet side trim
(2)
Measure 4" (102mm) from the top of
2
the side trim with a square ruler and mark
a cutting line (A).
Tools
Cut along the line using a fine tooth
3
hacksaw to a length of 76" (1930mm) (B).
IMPORTANT!
Ensure the cut is straight and square
● ●
as this is an exposed surface.
Ensure the plastic part does not bend
Hacksaw
● ●
as this can cause visual stress marks.
Repeat for all side trims.
Pencil
TWO METHODS ARE AVAILABLE FOR ATTACHING CABINET SIDE TRIMS:
[A] FLEXIBLE SPRING CLIP METHOD — RECOMMENDED METHOD
@5 CABINET TRIMS INSTALLATION — [A] FLEXIBLE SPRING CLIP METHOD
Discard
Aluminum
Place three side trim brackets onto each
4
side trim.
Note: Measure from the top of the trim,
with the shorter lip at the bottom.
Refer to (B) for 80" and 84" bracket
locations and trim orientation).
IMPORTANT!
Each bracket has two engagement points
for the side trim to locate. Ensure the trim
is engaged in both points (C).
Repeat for the remaining side trim.
A
Side trim
Plastic
bracket
short lip
Side trim
C
Top view of side trim engaged
correctly in side trim bracket
0
80" = 9" (229mm)
84" = 13" (330mm)
80" = 36" (914mm)
84" = 40" (1016mm)
80" = 65" (1651mm)
84" = 69" (1753mm)
B
37