Tools
Attach the door panels
Open the door and loosen the M5x10 cross-head screws
1
(do not remove) at the sides of the doors (A).
Hang the door panel by inserting the M8 studs
2
through the holes of the hanging bracket (B).
FPA spanner
Slide the forks of the side brackets onto
3
the screws of the door (C).
Screw the M8 washer and nut to each stud
4
(D) using the hex key, and re-tighten the
side screws (E) to fix the door panel
Hex key
(do not fully tighten). This will allow
opening the door without affecting
adjustment of the door panel.
Cross-head screwdriver
Powered driver (optional)
!9
DOOR PANEL INSTALLATION — STAINLESS STEEL
A
E
C
B
25