Fisher & Paykel ACTIVESMART RS36W80 Series Installation Manual page 33

IMPORTANT!
Tools
Follow these steps to avoid difficulties in door panel adjustment and cosmetic cap fitment.
● ●
Adjust the door panels
FPA spanner
Place a ruler on the front of the appliance to check flushness top
1
and bottom, left and right.
– Ensure the gap between the top of the door panel and the
Hex key
– To reduce this gap, raise the appliance by turning all four
Cross-head screwdriver
Ruler
#8x16 mush washer screw
(1)
#8 x 16
Mush Washer
Twin Thread
Philips Screw
@0 DOOR PANEL INSTALLATION — CUSTOM
top cabinetry is not more than 1/4" (7mm).
adjustment nuts the same number of turns.
A
Each door panel has full axis adjustment to ensure
2
flushness with adjacent walls. To adjust the height of
the panel, turn the stud clockwise to raise or counter-
clockwise to lower the door panel (A).
Once satisfied with the alignment, secure M8 studs with
3
M8 washer and M8 nut (B). The top of the stud must
remain below the top face of the door panel.
Secure side bracket forks by
4
tightening side screws (C).
Repeat for all door panels.
Note:
– For depth adjustment,
loosen the side screws (10),
adjust the panels and then
retighten once satisfied.
– Further adjustment of door
panels can be achieved by
removing door panels then
loosening the fixing screws
for the hanging bracket and
moving the bracket sideways
to suit.
Loosely install locking bracket
5
into the pocket on the underside
of the door using a M8 stud (D).
– Slide the locking bracket out
until it touches the back of
the door panel. Fully tighten the M8 stud.
– Screw in place using a #8x16 screw through one
of the three slotted holes.
B
C
D
31