Trace - Toyota Expert EPS9000 Instruction Manual

TRACE

This operation moves the hoop along the embroidery range (maximum dimen-
sion: vertical × horizontal) of the design data.
When performing this operation, do not put your hands or others
under the needle or on the table.
Otherwise, you could get hurt when the needle or hoop has
moved.
1 Select TRACE.
* * * * * E M B S T A R T * * * *
A I S I N 1 2 3 . 1 0 O
0 1 / 1 5 : 2 3 4 5 6 7 8 9 A B < D > 1
FD07
CAUTION
!
1
Press
0 / 1 0 2 7
.
72
For details of trace operation, refer
to Page 85.
Trace operation is not allowed dur-
ing embroidering.
If you press the TRACE key during
tracing, the hoop stops traveling at
the nearest corner in the direction
of present traveling.
Tracing restarts when the TRACE
key is pressed again.