Wiring - Toyota Expert EPS9000 Instruction Manual

WIRING

1. Make sure that the power switch (2) of the power supply box (1) is OFF.
2. Insert the plug (4) of the DC power cord (3) securely into the power supply connector (5) of the embroidery
machine.
3. Insert the other plug (6) of the DC power cord (3) securely into the DC power supply connector (7) of the power
supply box (1).
4. Insert the plug (9) of the AC power cord (8) securely into the AC power supply connector (10) of the power supply
box.
5. Insert the plug (11) at the other end of the AC power cord (8) securely into the single-phase 100 to 240 V power
supply.
Connect the earth wire of the AC power cord to the earth terminal
It could cause electric shock unless the machine is grounded properly.
The mains plug must be accessible after it is connected to the supply socket, so that it can easily
be disconnected in an emergency.
Plug
Spec.
Voltage Rating
WARNING
!
(5)
(4)
DC power cord (3)
(6)
(7)
AC power cord (8)
Types of AC Power Cord
USA and Canada
125 V
16
Embroidery machine
Power supply box (1)
(9)
(10) Power switch (2)
(Switch: OFF position)
AC power source
(to the receptacle with earth terminal)
(11)
EU
250 V