If Machine Operation Is Interrupted - Toyota Expert EPS9000 Instruction Manual

IF MACHINE OPERATION IS INTERRUPTED

The machine stops to operate when any one of the following messages is shown on the LCD screen of the
operation panel box. Simultaneously, the LED flickers, and the buzzer starts to sound. In such occasion, check the
error message first and then press the EMERGENCY STOP button. Take necessary steps referring to the following
table.
Press the STOP key to silence the buzzer.
No. Error Message
1 EMERGENCY
STOP
2 check! SEWING
MOTOR
3 check! X MOTOR
FD07
Description
The EMERGENCY 1) The switch was pressed
STOP button was by mistake.
pressed.
2) The switch was pressed
as an error had been
detected.
Machine motor is 1) Thread is entangling on
locked. the rotary hook.
2) Not lubricated appropri-
ately.
3) Interference of the nee-
dle with the hoop hin-
dered machine
movements.
4) The needle hit a hard
object such as a button,
and further movements
were disabled.
[Note] If the cause is 3) or 4), check the needle if it has
5) Foreign matter is caught
by take-up lever, needle
bar, presser foot or
upper shaft pulley.
X-axis motor was 1) The embroidery hoop
locked. holder reached the right/
(Longitudinal left travel end position,
direction) causing motor overload.
2) The material is caught
by such as the edge of
the table, disabling
embroidery hoop move-
ments any more.
3) The embroidery hoop
has been hit against
such as the wall and
cannot move any more.
95
Cause
• Reset the switch if it was
pressed by mistake.
• When there was an
error, remove the cause
of error and then reset
the switch.
• Remove thread from the
rotary hook.
• Supply lubricating oil to
the lubricating points.
• Press the TRACE key
and check the relation-
ship between the size of
design and that of
embroidery hoop.
• Set the start point of the
design correctly.
• Change the embroidery
position.
Remove the hard object.
been bent or needle tip has been collapsed.
If any defect is found, replace the needle.
• Remove foreign matter.
• Set the start point of the
design correctly.
• Release the material and
start embroidery from the
beginning again.
• Remove object that dis-
ables embroidery hoop
movements and start
embroidery from the
beginning again.
Refer
Corrective Action
to
27

87
88
72
29
21


29

