Toyota Expert EPS9000 Instruction Manual page 29

11 Input the needle numbers in the order of needle change using the
numeric keys.
12 Press the SET key.
* * * C O L O R C H A N G E * * *
M O D E A U T O
0 1 / 0 4 :
13 The screen will display the information as shown below when the
hoop data setting is completed.
* * * * * E M B S T A R T * * * *
A I S I N 1 2 3 . 1 0 O
0 1 / 0 4 : 5 7 3 B
14 Set the fabric in the embroidery hoop.
15 Set the embroidery hoop in the embroidery machine.
16 Set the upper and under threads.
17 Press the TRACE key to check if the range of embroidery fits the size
and position of the embroidery hoop.
18 If the hoop position does not fit the range of embroidery, adjust the
position of the hoop using the hoop travel keys and repeat step 17
again.
If the hoop size does not fit the range of embroidery, change the hoop
(to be purchased separately) to the one that fits the range of
embroidery.
19 After confirming that the hoop is set in the correct position, press the
START key.
Embroidering starts up.
FD07
Press
1
0 / 2 4 5 1
< D >
.
29
Various kinds of setting can be
made after completing the setting
of hoop data.