Alpha ESS Storion-SMILE T10 Installation Manual page 9

INSTALLATION
Figure 15 Assembling Battery Brackets
Use a screwdriver to assemble the battery mounting bracket onto the outside of the
Step 3
battery, as Figure 12 shows.
Figure 16 Placing Battery
Confirm the installation place at first.
Step 4
Push the battery against the wall and confirm the location of the battery with a horizontal ruler.
Place the PE bag on the battery to block out the dust before drilling.
Please drill four holes (two on each side) directly on the wall at the marking positions of the
brackets with an impact drill (bit φ 8.0mm, length 20cm), and the depth of each hole should be
about 7 cm.
13 14
Insert the expansion tube into the drilled hole. Pass the expansion screw through the
Step 5
gasket and lock with a screwdriver, as Figure 14 shows.
M4856-S is stackable with maximum of 4 batteries in each row. To install another battery repeat
Steps 1~5
Take the HV50056 out of the packaging box. Pull out the top two guide rods and remove
Step 6
the front panel. Remove the rear bracket from the HV50056, as shown in Figure 17.
Figure 17 Mounting Battery
Figure 18 Unpacking the High-voltage Control Box
INSTALLATION