Setting - Alpha ESS Storion-SMILE T10 Installation Manual

EMS INTRODUCTION AND SET UP

4.2 Setting

Figure 43 Password Interface
Step 1 Click setting and enter the
password.
The installation's password is four-digit
password: 1111, after the password is
correctly entered, you shall be at the main
Setting interface (administrator
permissions).
Figure 45 Function Interface
Step 3 Click Solar to set the Solar relevant
information.
Figure 47 Battery Model Interface
Step 5 Click the Battery Function and
check battery type M4856-S.
Figure 44 Setting Menu
Step 2 Click Function to enter function
setting.
Figure 46 Solar Setting Interface
Step 4 Set PV capacity, the total capacity
of PV capacity of T10-INV and PV inverter
(if it is installed).
Figure 48 SOC Calibration Interface
Step 6 Check SOC Calibration function set
No.
33 34
Figure 49 CT Meter Option Interface
Step 7 Choose CT Meter. If you use CT,
please enter the relevant CT ratio. If you
don't use CT, please enter the ratio as 1.
Figure 51 Max. Feed in rate Setting
InterfaceInterface
Step 9 Set the Max. Feed in rate value.
Figure 53 Work Mode Setting
Interface
Step 11 Click the mode then set up work
mode.(self-use or force time charge)
EMS INTRODUCTION AND SET UP
Figure 50 Grid Setting InterfaceInterface
Step 8 Click the Grid Function to set up
relevant parameters about the grid.
Figure 52 System Mode Setting
Interfaceterface
Step 10 Click Function-System Mode to
set system mode: DC, AC, Hybrid.
Figure 54 Force Charge Setting Interface
Step 12 If you want to use force charge,
set Enable here.