Alpha ESS Storion-SMILE T10 Installation Manual page 10

INSTALLATION
Figure 19 Fixing the Rear Bracket of HV50056
Fix the HV50056 rear bracket as shown in Figure 16.
Step 7
Find the positioning point and mark it.
1
Use the impact drill (drill φ10.0mm, length 20cm) to directly drill the hole in the marking position
2
of HV50056 rear bracket, the depth of the drilled hole should be 7cm.
After the drilling is completed, insert the expansion tube into the drilled hole, and fix the rear
3
bracket with a 10mm self-tapping screw by using 10MM sleeve (SW10).
Fix the HV50056 box rear bracket with the flange nut and use a 7MM sleeve on the two L-shaped
4
brackets of the battery (SW7).
NOTE: Place the PE bag on the battery to block out the dust before drilling.
Figure 20 Fixing of the Rear Bracket of HV50056
15 16
Fix the bracket A of the inverter on the rear bracket of HV50056 with the flange nuts, as
Step 8
shown in Figure 18.
The bottom of the bracket A shall be placed at the same horizontal line with the rear bracket of
HV50056.
Fix the inverter B bracket as shown in Figure 19.
Step 9
Find the positioning point and mark it.
1
Use the impact drill (drill φ10.0mm, length 20cm) to directly drill the hole in the marking position,
2
the depth of the hole is about 7cm.
After the drilling is completed, insert the expansion tube into the drilled hole, and fix the bracket
3
B with a 10mm self-tapping screw by using 10MM sleeve (SW10).
Fix bracket B with the flange nut and use a 7MM sleeve on the two L-shaped brackets of the
4
battery (SW7).
Figure 21 Installation of the Bracket A of the Inverter
Hanging Position for the Inverter
Hanging positions for the HV50056
Figure 22 Installation of the HV50056 and the Inverter
INSTALLATION INSTRUCTIONS