Network Control - Canon LH-WU350UST User Manual

Network control

Network control operation
Function: This function is designed to remote control computer in the same LAN.
Preparation
1 Required equipment: Projector, computer, network cable
2 Connection:
Connect your projector to a router or switch in the LAN with normal or jumper network
cable. In case a normal network cable failed to connect successfully, use a jumper cable
instead.
3 Turn on the computer. The LAN port on computer and projector are flashing after power
on the projector.
Operation steps
1 Power on your projector.
2 Acquire the IP address, with DHCP set to on
and auto IP allocation set to On. (You may set
DHCP to Off and set up IP address manually
if you are somehow familiar with networking.)
3 Enter the network setup menu
(1) Press MENU button on remote controller
or top control panel, press
select network icon.
(2) Press ENTER button or
network menu displays.
(3) Press button select network settings
and press ENTER to confirm.
(4) Press button to set DHCP On and
press OK button to confirm.
(5) Press button to select Set, press
OK button to wait until the "Please wait.."
message disappears.
button to
button and the
71
Advanced
Network
Network setting
Network information
MAC address:
IP address
LAN
Network setting
DHCP On
IP address
.
Subnet
.
Gateway
.
DNS
.
Set
：Move OK ：Next
LAN Network setting
DHCP Off
IP address 192 . 168
Subnet
255 . 255 . 255 .
Gateway
192 . 168 .
DNS
192 . 168 .
Set
：Move OK ：Next
7C:6F:F8:4E:B9:2F
192.168.1.100
. .
. .
. .
. .
Cancel
：Back
MENU
. 1 . 100
0
1 . 1
1 . 1
Cancel
：Back
MENU