Table of Contents
Advertisement
Network control
iii. You can adjust the LAN Settings.
iv. Once set, access to the remote network operation page on this projector has been passwordprotected.
To enable this function, check the box in front of "Enable" and type in your desired password in the New
Password column and confirm the new password by re-entering the new password at the Confirm
column. To disable password protection, uncheck the box.
v. Once set, access to the Tools page has been password-protected. Refer to step iv for how to use
the password function.
vi. Press Exit to go back to the remote network operation page.
•
After making the adjustments, press the Send button and the data will be saved in the projector.
•
Once the password is set, the Log Out button will display beside the Tools button.
•
Write down your selected password in advance or right after the password is entered so that it is available to
you should you ever forget it.
•
If you did not write down your password, and you absolutely do not remember it you can reset the
password by settings to [Factory default](P67)..
•
The software is available in English language.
•
When DHCP is turned on, there is a possibility of stopping the webpage connection. If thishappens,
please check the new IP address of the projector and enter the new address to connect again.
4.
The Info page displays the information and status of this projector.
i. The information you entered in the Tools page will display here and these columns are empty
when you use e-Control™ for the first time.
ii. When the projector is in abnormal conditions, the following information will display.
When the projector is in normal conditions or in any abnormal conditions other than the ones mentioned below,
the Error Status column will be "0:No Error".
Error Status
3: Light source fail
3: Over Temp
3: Fan Lock
3: Over Light source
i
i
iii
Description
The light source fails to ignite or turns off during operation.
The projector temperature is too high or cannot be detected.
The fan rotation speed cannot be set or detected.
Usage Time The light source is still in use after the light source
warning messages display.
81
ii
Advertisement
Table of Contents
