Operating Instructions - Bio Compression Systems SC-3008-DL Operating Instructions Manual

Operating Instructions

The patient is the intended user and can safely use all functions.
Preparing the Device for Use
• Remove garment(s) and cardboard underneath from box
• Lift pump out of box and remove protective end caps – save packaging for transport
and storage
• Place pump on a flat sturdy surface – pump must be close enough for the controls to
be reached during use
• Attach power cord and plug into outlet
• Remove garment(s) from plastic bag, unroll, and spread flat
Connecting the Garment(s)
• Locate the connector bar at the end of garment tubing
• Line up numbers on connector bar with numbers on pump
• Squeeze the sides and insert into pump – you will hear a "click" when connected
• Locate the second connecter bar and repeat previous steps
• When using two garments, remove blocker bar(s) and repeat previous steps
Putting the Garment(s) On
• Leg sleeve: unzip, place foot in and use straps to guide garment on, pull up zipper to
secure
• Arm sleeve: slide arm through larger opening
Operating the Device
• Sit in a comfortable reclined position with legs elevated within reach of controls
• Press "Power On/Off" button to turn on
• Hours of use will appear for 5 seconds followed by the mode
• The device will start at a pressure of 50 mmHg for a duration of 1-hour (to change, see
below)
• Upon the completion of treatment or to stop treatment, press "Power On/Off" button to
turn off
• Wait until light goes out
• Squeeze sides of connector bar and pull to disconnect garment from pump
• Press garment to remove remaining air until loose enough to remove
• Unzip (if applicable) and remove garment
To change mode
• Begin with device turned off
• Press "Power On/Off" button
8