Declaration Of Parameters - Siemens SIMATIC ET 200SP Manual

4.2

Declaration of parameters

Diagnostics: No supply voltage L+
Enabling the diagnostic alarm for missing or insufficient supply voltage L+.
Diagnostics port
This parameter allows the enabling of the diagnostics for the selected port.
The possible diagnostics are dependent on the IO-Link device used. Additional information
about the diagnostic interrupts can be found in the description of the utilized IO-Link device.
Potential group
With the "Potential group" parameter, you specify whether the module is inserted on a light-
colored or dark-colored BaseUnit.
A potential group always starts with an I/O module that is inserted on a light-colored
BaseUnit. All modules inserted to the right of this on dark-colored BaseUnits belong to the
same potential group, because the dark-colored BaseUnits are supplied via the light-colored
BaseUnits.
The potential group ends with a new light-colored BaseUnit or the end of the station.
PortQualifierInformation
This parameter enables the PortQualifierInformation (PQI).
The PQI provides information on the port and IO-Link device status.
Port configuration without P7-PCT
This parameter enables the port configuration without S7-PCT for the module.
Communication module IO-Link Master CM 4xIO-Link (6ES7137-6BD00-0BA0)
Manual, 10/2017, A5E03856846-AD
Parameters/address space
4.2 Declaration of parameters
23