Declaration Of Parameters; Address Space - Siemens SIMATIC ET 200SP Manual

Parameter assignment/addressing

4.2 Declaration of parameters

4.2 Declaration of parameters
Diagnostics missing supply voltage L+
Enabling of the diagnostics for missing or insufficient supply voltage L+.
Short-circuit to ground diagnostics
Enabling of the diagnostics in the event of a short-circuit of the sensor supply to ground or of
an input to the sensor supply.
Diagnostics wire break
Enabling of the diagnostics if the module has no current flow and/or the current is too weak
for measurement at the correspondingly configured input.
Operating mode
Determines whether a channel is enabled or disabled.
Input delay
Determines how high the input delay is for a channel.
BaseUnit with incoming supply voltage
Specifies whether the I/O module is located on a BaseUnit with incoming voltage supply (see
system manual ET 200SP distributed I/O system
(http://support.automation.siemens.com/WW/view/en/58649293)).
4.3

Address space

Address space of the digital input module DI 8×24VDC ST
The following image shows the assignment of the address space.
Figure 4-1
14
Address space of the digital input module DI 8×24VDC ST
DI 8x24VDC ST digital input module (6ES7131-6BF00-0BA0)
Manual, 03/2012, A5E03574157-01