Panasonic ST4 Series Instruction Manual page 15

Designation
18 Setting switches
Terminal block connector
19 area
© Panasonic Industrial Devices SUNX Co., Ltd. 2016
No.
Sets ST4-A□ to the muting condition.
1 to 4 Sets muting / override effective time.
For details, refer to "3-9 Muting Pattern Selection Function."
Use this switch when it is required to check the beam
received / interrupted condition of connected ST4-A□, or
5
the sensor error.
For details, refer to "3-10 Sensor Diagnosis Function."
6
Unused
7
Use this switch when it is required to invalid the muting
8 lamp diagnosis. For details, refer to "3-11 Muting Lamp
Diagnosis Function."
Terminal
Name
S+ Muting input power supply (24V)
S-A Muting input S-A (For PNP output type sensor)
S-B Muting input S-B (For NPN output type sensor)
S- Muting input power supply (0V)
S+ Muting input power supply (24V)
S-C Muting input S-C (For PNP output type sensor)
S-D Muting input S-D (For NPN output type sensor)
S- Muting input power supply (0V)
S+ Muting input power supply (24V)
S-E Muting input S-E (For PNP output type sensor)
S-F Muting input S-F (For NPN output type sensor)
S- Muting input power supply (0V)
AUX1 Auxiliary output 1 (muting function)
AUX2 Auxiliary output 2 (override function)
AUX3 Auxiliary output 3 (lamp shutoff)
AUX4 Negative logic of the control output (OSSD 1 / 2)
OSSD 1
Control output (OSSD 1 / 2)
OSSD 2
L1
Muting lamp connecting terminals
L2
A1 24V DC
A2 0V
IL+
Interference prevention terminals (downstream)
For details, refer to "3-4 Interference Prevention Function."
IL-
IU+
Interference prevention terminals (upstream)
For details, refer to "3-4 Interference Prevention Function."
IU-
O1
Override input terminals
O2
X1
Reset input terminals (When X1 and X2 are connected:
X2 manual reset, and when X1 and X3 are connected: auto
reset
X3
T1
Emission halt input terminals (Open: emission halt,
Short-circuit: emission)
T2
Functional Description
Function
ON 1 2 3 4 5 6 7 8
Description
Description
15