Panasonic ST4 Series Instruction Manual page 26

Safety Distance
<Connecting example 2>
In case of branching between ST4-A□ and ST4-CCJ05-WY when six units
of ST4-A□ are connected
Branch cable
ST4-CCJ05-WY
(Optional)
<Reference>
Addresses are automatically allocated in order of arrows shown in the above figure.
26
Emitter of ST4-A□
Address 6
6
Address 5
5
Address 4
4
Address 3
3
Address 2
2
Address 1
1
Extension cable
ST4-CCJ□
(Optional)
● Addresses of ST4-A□ are allocated in order of the numbers that
are marked on the main body of ST4-CCJ05-WY (optional).
● Make sure to connect ST4-A□s to the connector 2 and 3 of the
ST4-CCJ05-WY (optional). If ST4-A□s are not connected to the
connector 2 and 3, the device does not operate properly. In case of
unconnected condition, the fault indicator (yellow) of ST4-C11 blinks
once. In case of ST4-C12EX, "
© Panasonic Industrial Devices SUNX Co., Ltd. 2016
Receiver of ST4-A□
Address 6
Address 5
Address 4
4
Address 3
Address 2
Address 1
ST4-C11 or
ST4-C12EX
" is indicated on the fault display (red).
6
5
3
2
1
Connector No.