Chapter 6 Specifications / Dimensions; Specifications; Controller St4-C11 / St4-C12Ex - Panasonic ST4 Series Instruction Manual

Chapter 6 Specifications / Dimensions

6-1 Specifications

6-1-1 Controller ST4-C11 / ST4-C12EX

Item Model No.
Supply voltage
Current consumption
Control output
(OSSD 1 / 2) (Note 1)
Output operation
Short-circuit protection
Response time
Auxiliary output (Note 1)
Output operation
Short-circuit protection
Muting lamp output
(Note 1)
Short-circuit protection
© Panasonic Industrial Devices SUNX Co., Ltd. 2016
Type Controller
ST4-C11
0.1A or less
PNP / NPN open-collector transistor
Dual output × one system (output form can be selected by switch)
<PNP output>
• Max. source current: 200mA
• Applied voltage: same as the
(between control output and +V)
• Residual voltage: 2.5V or less
(At 200mA source current)
• Leakage current: 200µA or less
(Including power OFF condition)
• Maximum load capacity: 1µF
(From no-load to max. output current)
• Load wiring resistance: 3Ω or less
ON when all beams of the connected ST4-A□s are received.
OFF when one or more beams of the connected ST4-A□s are inter-
rupted (except during muting when ST4-C12EX is used.)
OFF response: 25ms or less
ON response: 90ms or less (auto reset) / 140ms or less (manual reset)
PNP / NPN open-collector transistor
ST4-C11: one output (output form can be selected by switch)
ST4-C12EX: four output (output form can be selected by switch)
<PNP output>
• Max. source current: 100mA
• Applied voltage: same as the
(between auxiliary output and +V)
• Residual voltage: 2.5V or less
(At 100mA source current)
OFF when all beams of the con-
nected ST4-A□s are received.
ON when one or more beams of
the connected ST4-A□s are inter-
rupted
24V DC % Ripple P-P 10% or less
+10
-15
<NPN output>
• Max. 200mA sink current
• Applied voltage: same as the
supply voltage
• Residual voltage: 2.0V or less
• Leakage current: 200µA or less
• Maximum load capacity: 1µF
• Load wiring resistance: 3Ω or less
Incorporated
<NPN output>
• Max. 100mA sink current
• Applied voltage: same as the
supply voltage
(between auxiliary output and 0V)
• Residual voltage: 2.0V or less
<Auxiliary output 1>
ON when muting function is invalid
OFF when muting function is valid
<Auxiliary output 2>
ON when override function is invalid
OFF when override function is valid
<Auxiliary output 3>
ON when muting lamp is in normal condition
OFF when muting lamp is in abnormal condition
<Auxiliary output 4>
Negative logic of the control output
(OSSD 1 / 2)
Incorporated
—
Incorporated
Multifunctional controller
ST4-C12EX
0.12A or less
supply voltage
(between control output and 0V)
(At 200mA sink current)
(Including power OFF condition)
(From no-load to max. output current)
supply voltage
(At 100mA sink current)
Available muting lamp:
24V DC, 1 to 10W
71