Siemens SIMATIC NET CP 443-5 Extended Manual page 4

Preface
Printed circuit board protected against dust and moisture by additional coating (conformal
coating).
Note
Names
• In this document, the term "CP" is used at times instead of the full product name.
• Instead of the full names of the configuration tools STEP 7 V5.5 and
STEP 7 Professional, the STEP 7 verwendet name is used.
Structure of the documentation
The documentation for this device consists of the following parts:
● Manual Part A - Configuration manual "Configuring and Commissioning S7 CPs for
PROFIBUS"
You will find this manual on the Manual Collection DVD that ships with every CP or on the
Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/de/view/1158693)
● Manual Part B - manual "S7 CPs for PROFIBUS - CP 443-5 Extended" ( this manual)
Purpose of the manual
This manual describes the properties of this device and shows application examples.
The manual supports you when installing, connecting up and commissioning the device.
The required configuration steps for the device are described.
You will also find instructions for operation and information about the diagnostics options of
the device.
New in this edition
● New ATEX/IECEx approval
● Editorial revision
Note
Compatibility with previous versions
Read the information relating to enhanced functions and any restrictions that may apply in
the section Compatibility with previous product (Page 24).
Replaced edition
Edition 11/2016
4
CP 443-5 Extended
Manual, 11/2018, C79000-G8976-C162-09