Grizzly G0834 Owner's Manual page 43

4. Remove front and rear table covers to
expose eccentric bushings, as shown in
Figures 54–55.
Front Table
Cover
Figure 54. Removing front table cover.
Front
Eccentric
Bushings
Rear
Eccentric
Bushings
Figure 55. Locations of front and rear eccentric
bushings.
Model G0834 (Mfd. Since 12/17)
5. Loosen set screw on each eccentric bushing
(see Figure 56).
Set Screw
(1 of 4)
Figure 56. Location of eccentric bushing set
screw.
6. Place straightedge on outfeed table so it
hangs over cutterhead, rotate motor pulley so
straightedge is between inserts, then lower
outfeed table until straightedge just touches
cutterhead body, as shown in Figure 57.
Straightedge
Outfeed Table
Figure 57. Adjusting outfeed table even with
cutterhead body.
-41-