Grizzly G0834 Owner's Manual page 21

2. Lift fence assembly over fence carriage, slip
sliding bushing into the fence carriage slot,
ensuring key fits snugly into key slot, as
shown in Figure 16.
Fence
Keyway
Slot
Key
Carriage
Figure 16. Aligning fence assembly and fence
carriage.
3.
Secure sliding bushing with (1) M12-1.75 lock
nut and (1) 12mm flat washer, as shown in
Figure 17.
Sliding
Bushing
Figure 17. Securing sliding bushing.
4. Position and tighten fence tilt handle, as
shown in Figure 18.
Fence Tilt
Handle
Figure 18. Positioning and tightening fence tilt
handle.
Model G0834 (Mfd. Since 12/17)
5.
Sliding
Bushing
Carriage Slot
6.
7.
Install cutterhead guard shaft into mounting
hole, as shown in Figure 19, then secure it
using lock knob.
Cutterhead Guard
Lock Knob
Figure 19. Installing cutterhead guard.
Cutterhead guard is a critical safety feature
of this jointer. You MUST install and verify
its operation before using the jointer! Failure
to properly install this guard will greatly
increase risk of serious personal injury.
Move fence all the way to back of table, then
pull cutterhead guard back and let it go.
It should spring back over cutterhead and
contact fence.
— If cutterhead guard does not spring back
over cutterhead and contact fence, then
cutterhead guard tension must be adjust-
ed (refer to Adjusting Cutterhead Guard
Tension on Page 44 for instructions).
Perform Setting Outfeed Table Height on
Page 37.
Cutterhead
Guard Shaft
-19-