Platform Setup - Dell EMC SD-WAN Edge 600 Series Installation Manual

Start up sequence
When the platform powers up, the fans immediately come on at high speed. The fan speed slows as the platform continues to boot.

Platform setup

WARNING: To avoid electrostatic discharge (ESD) damage, wear grounding wrist straps when handling this equipment.
Install the device in an area that meets the following safety requirements:
• Near a properly grounded AC power outlet.
• In a temperature-controlled room with a temperature range from 0°C to 40°C (32°F to 104°F).
• In a dry, clean, and well-ventilated room away from heat sources such as hot air vents or direct sunlight
• Away from severe electromagnetic noise
The numbers one through four in the following figure correspond to the setup procedure:
1. Connect the power adapter to the AC power outlet. Connect the other end of the power adapter to the power port on the Edge.
When the Edge powers ON, verify that the status LED on the front of the Edge is on.
NOTE: Connect the device to a properly wired earth-ground AC power outlet.
2. Connect one of the default WAN ports (GE3-6 or SFP1-2) to an available Internet connection. SFP modules are not included.
a. 1—SFP 1-2
b. 2—GE 3-6
NOTE: By default, the Edge gets a DHCP IP address from the ISP on the WAN uplink. When the WAN connection is
fully operational, the cloud LED on the front of the Edge is green.
3. If you received an email from your IT administrator, follow the instructions in the email to complete the Edge activation.
If you did not receive an email, request the setup instructions for your IT administrator or contact your Dell EMC sales representative.
Edge 600 Series installation 17