Breakout Cable; I/O Module Cable - Cognex In-Sight Micro Series Installation Manual

Breakout Cable

The Breakout cable provides access to the vision system's trigger and high-speed outputs. The Breakout cable can be
connected to devices, such as a PLC, trigger sensor or strobe light. The pin-outs for the cable are listed in the
Cable Specifications on page 25. This cable is available in the lengths listed below.
Length
0.6 m
2 m
5 m
10 m
15 m

I/O Module Cable

The I/O Module cable is used with the CIO-MICRO or CIO-MICRO-CC I/O module. The I/O Module cable connects the
vision system directly to the I/O module via the DB15 connector. When connected, the I/O Module cable provides access
to the vision system's trigger and high-speed outputs. The pin-outs for the cable are listed in the
Specifications on page 26. This cable is available in the lengths listed below.
Length
0.7 m
2 m
5 m
10 m
15 m
CCB-M8IO-00
CCB-M8IO-02
CCB-M8IO-05
CCB-M8IO-10
CCB-M8IO-15
CCB-M8DSIO-00
CCB-M8DSIO-02
CCB-M8DSIO-05
CCB-M8DSIO-10
CCB-M8DSIO-15
9
Introduction
Part #
I/O Module Cable
Part #
Breakout