Precautions - Cognex In-Sight Micro Series Installation Manual

Precautions

To reduce the risk of injury or equipment damage, observe the following precautions when you install the Cognex
product:
An IEEE 802.3af compliant, and UL or NRTL listed, Power over Ethernet (PoE) power source rated Class 0, 2, 3
l
or 4 must be used. Any other voltage creates a risk of fire or shock and can damage the components. Applicable
national and local wiring standards and rules must be followed.
This product is intended for industrial use in automated manufacturing or similar applications.
l
The safety of any system incorporating this product is the responsibility of the assembler of the system.
l
Route cables and wires away from high-current wiring or high-voltage power sources to reduce the risk of
l
damage or malfunction from the following causes: over-voltage, line noise, electrostatic discharge (ESD), power
surges, or other irregularities in the power supply.
Do not install Cognex products where they are exposed to environmental hazards such as excessive heat, dust,
l
moisture, humidity, impact, vibration, corrosive substances, flammable substances, or static electricity.
Do not expose the image sensor to laser light. Image sensors can be damaged by direct, or reflected, laser light.
l
If your application requires laser light that might strike the image sensor, use a lens filter at the corresponding
laser wavelength. For suggestions, contact your local integrator or application engineer.
This product does not contain user-serviceable parts. Do not make electrical or mechanical modifications to
l
product components. Unauthorized modifications can void your warranty.
Changes or modifications not expressly approved by the party responsible for regulatory compliance could void
l
the user's authority to operate the equipment.
Include service loops with cable connections.
l
Ensure that the cable bend radius begins at least six inches from the connector. Cable shielding can be
l
degraded or cables can be damaged or wear out faster if a service loop or bend radius is tighter than 10X the
cable diameter.
This device should be used in accordance with the instructions in this manual.
l
5
Precautions