Install The Mounting Block (Optional); Install The Lens - Cognex In-Sight Micro Series Installation Manual

Install the Mounting Block (Optional)

The mounting kit includes a mounting bracket and M3 screws (quantity 4) for mounting the vision system and securing it
to a mounting surface. The mounting bracket also has 1/4 - 20 and M6 mounting holes available for mounting the vision
system to a mounting surface. For more information, refer to
1. Align the mounting block with the mounting holes on the vision system.
2. Insert the M3x6 (quantity 4) screws into the mounting holes and tighten the screws using a 2.5mm hex wrench;
the maximum torque is 0.9039 Nm (8 in-lb).

Install the Lens

1. Remove the protective film covering the threaded lens opening, if present.
2. Attach a CS-Mount or C-Mount (with 5mm extension ring) lens to the vision system. The exact lens focal length
needed depends on the working distance and the field of view required for your machine vision application.
Vision System Dimensions on
11
Installation
page 27.