Connect The Ethernet And Power; Connect The Power Wires - Cognex In-Sight Micro Series Installation Manual

Connect the Ethernet and Power

The vision system's PoE connector provides the Ethernet connection for network communications and supplies power to
the vision system. The following steps illustrate how to connect the In-Sight Micro vision system to the In-Sight
CIO-MICRO or CIO-MICRO-CC I/O module. If neither I/O module is used, a third-party PoE injector or a PoE switch must
be used to supply power to the vision system.
Note: For detailed connection information, see the In-Sight
Installation Manual.

Connect the Power Wires

CAUTION: Never connect the I/O module to a power source other than 24VDC. Any other voltage creates a risk of
fire or shock and can damage the hardware. Do not connect the 24VDC power source to any terminals other than
the 24VDC + and – power terminals.
1. Verify that the 24VDC power supply is unplugged and not receiving power.
2. Use a screwdriver to loosen the I/O module's power terminals (labeled 24VDC + and –).
3. Insert the 24VDC + and – wires (16 - 22 AWG, solid or stranded wire) from the power supply into the 24VDC +
and – terminals on the I/O module.
4. Tighten the screw terminals with the screwdriver to secure the wire leads in the terminal block; the maximum
torque is 0.1921 Nm (1.7 in-lb).
®
CIO-MICRO and CIO-MICRO-CC I/O Module
14
Installation