Table of Contents
Advertisement
VC series bench scales Technical Manual
SECTION 2. UNPACKING & INSTALLATION
2. 1. Unpacking
Unpack the container carefully. Examine the packaging and the device for any
damage, and report it to the shipper if there is any. Try to keep the scale upright.
Check for enclosures as follows:
Scale platform
Stainless steel pan
Weighing indicator
AC Adapter
Operation manual
Ni-MH battery (optional)
Note :
1. If any items are missing or any damage is discovered immediately notify your
place of purchase or a dealer.
2. Keep box and shock absorber pad after installation. They are required for
transportation.
2. 2 Installing the scale
The pillar is attached to the base using a bracket that must first be attached to the
base frame using the 4 bolts supplied. The Pillar is secured to the bracket using 2
set screws. The cable from the base to the indicator module is run through the tube,
out through the plastic support at the top. Excess cable can be stored within the
tube.
The VC Series comes with a stainless steel platform packed separately. Place the
platform in the base.
Attach the indicator module to the pillar by sliding it over the bracket with the flanges
engaged in the groves on the base.
Attach the cable from the base to the
connector on the rear of the indicator.
2. 3 To Level the Scale
Level the scale by adjusting the four feet. The scale should be adjusted such that the
bubble in the spirit level is in the centre of the level and the scale is supported by all
four feet. If the scale rocks readjust the feet.
The scale must be level for proper operation. Use the 4 level adjusters located at
the 4 corners of the scale main unit to adjust the horizontal position of the scale
until the bubble of the bubble level lies within the red circle. Ensure that the
scale sits solidly and does not wobble due to uneven adjustment.
- 2 -
Advertisement
Table of Contents
