Table of Contents
Advertisement
value is memorized.
5.4 Accumulation.
5.4.1 normal accumulate counting
before do accumulation operate, please set unit weight, then load partial
samples, quantity window will show current counts, after
key, quantity windows will show current total weight (TOTAL indicator
on) for 3 second, then return to normal count mode.
Please note, before you stare next accumulate, scale must return to zero.
5.4.2 Accumulation mode
When in normal count mode, press
mode. Weight window will show current count value, unit weight will show new
total weight, quantity window show current total weight (TOTAL indicator
flash).
In accumulation mode, after add sample and O indicator on, press
quantity window will show total count.
5. 5 Limit set and Comparing
5.5.1 Limit Set
Before use this function, pleas sure limit function must be set enable ( see
detail in parameter setting table), you can set either one point or two points
limit.
Press
that currently set at UNIT.W display, enter low limit value with numerical keys,
press
appears at Weighing display, and high limit value shows that currently set at
UNIT.W display, then advance to the high limit, enter high limit value with
numerical keys, press
High limit set, and go back to working area.
5.5.2 Look up limit values
- 8 -
VC series bench scales Technical Manual
key. Li-LO appear at Weighing display, and low limit value shows
key. Low limit set, and a beep will sound to sign. Then Li-HI
key. High limit set, and a beep will sound to sign.
○ indicator on
key, scale will enter accumulation
, press
key,
Advertisement
Table of Contents
