Table of Contents
Advertisement
Displaying Information
Remote control
INPUT
ON/STANDBY
LASER
AUTO
KEYSTONE
SET
L-CLICK
R-CLICK
VOLUME/ADJUST
MENU
ENTER
EXIT
PIP
FREEZE
RESIZE
CALL
MUTE
CALL
Information on the input signal source, etc., can be displayed.
Press CALL.
CALL
The information described below is displayed.
The information display turns off when the CALL button is
pressed again.
Status display
Input
- current input source
H-resolution - the horizontal resolution of the input signal (at RGB input)
V-resolution - the vertical resolution of the input signal (at RGB input)
H-frequency - the horizontal frequency of the input signal (at RGB input)
V-frequency - the vertical frequency of the input signal (at RGB input)
Sync
- the polarity of the sync signal (at RGB input)
Video mode - the color mode of the video signal (at Video, S-Video input)
Signal format- the formatting of the Y/P
Lamp time
- the elapsed usage time of the lamp
Version
- the version of the firmware
Shutter
- the shutter speed of the document imaging camera (at
document imaging camera input)
Notes
• The information displayed is not refreshed even if it changes. To refresh the information, turn
off the information display, then turn it back on.
• The information display turns off if any other operation is performed.
• The "Lamp time" shows an approximate time for lamp replacement. (It should not be used as a
lamp warranty time counter.) If the time indicated here nears 1000, contact your store of
purchase about obtaining a replacement lamp (TLPL78, sold separately).
• The "Lamp time" can be reset when the lamp is replaced.
• The "Version" is the version of the control program used in the projector and is used for
servicing, etc.
CONTENTS
/P
signal (at Y/P
/P
input)
B
R
B
R
41
Advertisement
Table of Contents
