Displaying Information (Status Display) - Toshiba TDP-P8 User Manual

Using the menu (Continued)

Displaying Information (Status display)

This displays information about the input signal, lamp use time, etc.
Item
Input
Mode name
H-resolution
V-resolution
H-frequency
V-frequency
Sync
Signal format
Video mode
Lamp time
Lamp reset count
Total time
Version
Notes
1: The mode of supported RGB signals p.39 is shown.
2: Same as the refresh rate of the computer signal.
3: Sync signal polarity shown as P (positive) or N (negative) for [H/V].
4: Displays [Lamp time] as a measure of when the lamp should be replaced. (Cannot be used as a
counter of guaranteed lamp time.) When the displayed time approaches 2,000 hours, consult with a
store about getting a TLPLP8 replacement lamp (sold separately) prepared.
5: [Version] shows the version of the projector's internal control program. This version is referred to for
customer service, etc.
Note
• The displayed information will not be refreshed if the status changes. To refresh the
information, dismiss the display, then display it again.
Description
Input source name
[Note 1]
RGB input mode
Horizontal resolution (in dots)
Vertical resolution (in dots)
Horizontal sync frequency
Vertical sync frequency
Sync signal polarity
Y/P /P signal format
B R
Color method of video signal
[Note 4]
Time of lamp use
The count for lamp replacement
The total time that this projector is used
[Note 5]
Firmware version
"Yes": displayed, "No": not displayed
[Note 2]
[Note 3]
34
Computer Y/P /P
B R
Yes Yes
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
No Yes
No No
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Video
S-video
Yes
No
No
No
No
No
No
No
Yes
Yes
Yes
Yes
Yes