Table of Contents
Advertisement
Connecting a computer (COMPUTER IN 1 connector)
You can project the picture from the computer.
Check that the power supplies for the projector and for the computer are off before connecting the cables.
USB
MONITOR
OUT
CONTROL
Notes
• The projector cannot be connected to a computer without an analog RGB connector. For details, refer to the computer manual.
• You may not be able to connect some computers to the projector. For details, consult the dealer.
• When connecting to a Macintosh computer, use the supplied Mac adapter (Multiple Scan 21 compatible). For some models the adapter is not required.
• Some computers may have output modes which are not compatible with this projector. Check the compatibility of the connectors, signal levels, timing,
resolutions, etc.
COMPUTER IN 1
COMPUTER IN 2
( Y/P
)
/P
B
R
AUDIO
VIDEO IN
IN
R - AUDIO - L
VIDEO
S-VIDEO
To COMPUTER IN 1 connector
Be sure to connect in the proper
direction.
RGB cable (supplied)
To AUDIO IN jack
Audio cable (supplied)
COMPUTER IN 1 connector
For use as both analog RGB (1) and Y/P
factory, it is set for use as analog RGB (1) input.
AUDIO IN jack
For use as both audio signals for RGB input (analog RGB (1)/analog RGB (2)/
digital RGB) and Y/P
/P
input.
B
R
Connecting a Mac adapter for
Macintosh computers (supplied)
To monitor port
CONTENTS
/P
input. At shipping from
B
R
Computer
ø3.5mm stereo mini-jack
To audio output port
22
Advertisement
Table of Contents
