Table of Contents
Advertisement
Correcting the keystone distortion (continued)
Remote control
INPUT
ON/STANDBY
LASER
AUTO
KEYSTONE
SET
L-CLICK
R-CLICK
VOLUME/ADJUST
4,5
6
MENU
ENTER
EXIT
PIP
FREEZE
RESIZE
CALL
MUTE
Control panel
(Main unit side)
ON / STANDBY
VOL / ADJ
4,5
6
4
If the screen is not installed vertically,
"Auto. V-keystone" is not corrected
properly.
After confirming that "V-keystone" is selected on the menu;
Adjust the distortion of the both sides (right and left)
of the picture with the selection buttons (
5
When the projector is not installed at an angle of 90° to the
screen viewed from the top, the upper and lower sides of the
projected picture will be
distorted.
Select "H-keystone" from the menu with the
selection buttons ( / ), and adjust the
distortion of the upper and lower sides of the
picture with the selection buttons (
EXIT
6
Press EXIT repeatedly until the menu
disappears.
EXIT
The keystone adjustment finishes.
Notes
• Due to digital correction processing, some of the information may be eliminated or the picture
quality may be degraded depending on the amount of keystone correction or the contents of
the signal source.
• The adjustable range of "V-keystone" or "H-keystone" is influenced by each other's correction
amount, and each input signal
switching the input.
• When "Auto. V-keystone" does not operate properly even with the screen installed vertically,
execute "Horizontal reference value reset"
90°
71
. Therefore, the correction amount may change when
.
52
36
CONTENTS
/
).
/
).
Advertisement
Table of Contents
