Type 2 Without T-Harness - Xpresskit DBALL2 Installation Manual

Platform: DBALL2
Firmware: FORD6 Remote Start Ready (RSR) Installation

Type 2 without T-Harness

Important!
The Hood Pin and Remote Start Safety Override Switch are mandatory safety devices, but are NOT supplied with the DBALL2.
(+) Ignition:
White/Orange, pin 1
Ignition
Switch
(Black 7-pin
connector)
1A
Diode
4
3
TX:
2
Yellow/Orange,
1
pin 3
P.A.T.S. Connector
(Black 4-pin conn.
around ignition switch)
Ford Edge
1
2011+.
2
OR
3
4
Ford
5
Explorer 2011+.
6
7
8
(-) Power Liftgate:
Gray/Yellow,
Trunk Release
pin 7
(Black 8-pin
connector)
(Ford Explorer
only)
With the exception of the OBDII Diagnostic connector, all adapters are displayed from the wire side (unless specified otherwise).
OBDII
Diagnostic
Connector
Violet/Orange, pin 11
Driver Door Trigger: Green/Violet, pin 9
Cut
MS CAN High: Tan/Black: 3
MS CAN Low: Tan: 4
HS CAN High: Orange/Green: 5
HS CAN Low: Orange/Brown: 6
(+) 12V Input: Brown: 7
(+) Ignition Output: Yellow: 8
RAP Off Interrupt: Orange/Red: 10
RAP Off Interrupt: Yellow/Red: 11
(+) 12V Input: Red: 13
(-) Ground: Black: 14
(-) Lock Output: Green/Black: 2
(-) Unlock Output: Red/Black: 4
(+) Start Output: Gray: 6
(+) Accessory/Keysense Output: Gray/Black: 7
(-) Trunk Release Output: Violet/Brown: 9
TX: Yellow/Black: 10
RX: Orange/Black: 11
(-) Parking Lights Output: Blue/Red: 12
RX:
Violet/
Gray,
pin 4
87
87a
Fuse 25 Amp
86
30
MS CAN High: Gray/Orange, pin 3
HS CAN High:
White/Blue, pin 6
1 8
9 16
HS CAN Low: White, pin 14
MS CAN Low:
(-) Unlock: Yellow/Violet, pin 8
(-) Lock: Blue/Green, pin 6
1 2 3 4 5 6 7 8 9 10
14 15 16 17 18 19 20 21 22 23
RF
Prog. Button
LED
BCM/SJB Connector
(Gray 10-pin conn. drivers
kick panel or under dash)
1 2 3 4 5 6 7
6 1
85
7 2
(+) Parking Lights:
8 3
Yellow/Blue,
9 4
pin 6
10 5
Hood Pin
Note: hood pin only required
on vehicles not equipped with
a factory hood pin.
13
11 12
24 25 26
(-) Trunk Release: Brown, pin 23
(Ford Edge only)
Remote Start Safety
Override Switch
6: White/Black: (-) Hood/Remote
Start Safety Override Switch
DBALL2
You can connect to
either a XL202 RFTD
OR a SmartStart
module.
Refer to the
SmartStart/XL202
Installation Notes for
more information.
© 2017 Directed. All rights reserved.
Rev.: 20170516
Page 14