Xpresskit DBALL2 Installation Manual

Hide thumbs Also See for DBALL2:

Advertisement

Platform: DBALL2
Firmware: VW06
Update Alert: Firmware updates are posted on the web on a regular basis. We recommend
that you check for firmware and/or install guide updates prior to installing this product.
Installation Guide
The VW06 firmware for DBALL2 is an all-in-one door lock and override module compatible with
specific Audi and Volkswagen vehicles.
This module can only be flashed and configured using XpressVIP at www.directechs.com or
using the Directechs Mobile application for smartphones. Refer to the Module Programming
section on page 12 for more information.
Important!
This firmware does not support Immobilizer bypass. One (1) programmed OEM key must be wired into the
vehicle to complete the installation of a remote starter.
All information listed for the 2017 Golf R (Smart Key) is for automatic transmissions ONLY.
Index
Vehicle Application Guide...................................................................................................................................................
Type 1.................................................................................................................................................................................
Type 2.................................................................................................................................................................................
Type 3.................................................................................................................................................................................
Immobilizer Interface with OEM Immob. Receiver.............................................................................................................
Programming
Module Programming.........................................................................................................................................................
Module Reset.....................................................................................................................................................................
Hard Reset.........................................................................................................................................................................
Feature & Option List..........................................................................................................................................................
Feature Programming.........................................................................................................................................................
LED Diagnostics & Troubleshooting...................................................................................................................................
Limited One-Year Consumer Warranty...............................................................................................................................
Quick Reference Guide......................................................................................................................................................
® Audi and Volkswagen are registered trademarks and property of its respective companies.
Rev.: 20171012
02
03
05
07
10
12
13
13
14
14
15
17
18
© 2017 Directed. All rights reserved.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DBALL2 and is the answer not in the manual?

Questions and answers

Summary of Contents for Xpresskit DBALL2

  • Page 1: Table Of Contents

    Installation Guide The VW06 firmware for DBALL2 is an all-in-one door lock and override module compatible with specific Audi and Volkswagen vehicles. This module can only be flashed and configured using XpressVIP at www.directechs.com or using the Directechs Mobile application for smartphones.
  • Page 2: Vehicle Application Guide

    Platform: DBALL2 Firmware: VW06 Rev.: 20171012 Page 2 Vehicle Application Guide The following table lists the vehicles and features which are compatible with this product. The number assigned to each year allows you to determine which installation type should be used for your vehicle.
  • Page 3: Installation (Wiring Diagrams & Vehicle Wiring Reference Charts) Type 1

    Platform: DBALL2 Firmware: VW06 Rev.: 20171012 Page 3 Installation Type 1 (-) Hood Status Input (-) Lock Output (+) Ignition Status Input (-) Unlock Output (+) Brake Status Input (-) Trunk Release Output (AC) Tach Input (+) Ignition Output (-) Trunk Status Input...
  • Page 4 Platform: DBALL2 Firmware: VW06 Rev.: 20171012 Page 4 Type 1 - Vehicle Wiring Reference Chart Wire Information Connector Information Function Color Polarity Location Color Pins Audi A3 (Smart Key) & S3 (Smart Key) 2015-2018 HS CAN 1 High Orange/Red Data OBDII.
  • Page 5 Platform: DBALL2 Firmware: VW06 Rev.: 20171012 Page 5 Installation Type 2 (-) Hood Status Input (-) Lock Output (+) Ignition Status Input (-) Unlock Output (+) Brake Status Input (-) Trunk Release Output (AC) Tach Input (+) Ignition Output (-) Trunk Status Input...
  • Page 6: Type 2

    Platform: DBALL2 Firmware: VW06 Rev.: 20171012 Page 6 Type 2 - Vehicle Wiring Reference Chart Wire Information Connector Information Function Color Polarity Location Color Pins Audi TT (Smart Key) 2016-2017 HS CAN 1 High Data OBDII. Black HS CAN 1 Low...
  • Page 7: Type 3

    Platform: DBALL2 Firmware: VW06 Rev.: 20171012 Page 7 Installation Type 3 (-) Hood Status Input (-) Lock Output (+) Ignition Status Input (-) Unlock Output (+) Brake Status Input (-) Trunk Release Output (AC) Tach Input (+) Parking Light Output...
  • Page 8 Platform: DBALL2 Firmware: VW06 Rev.: 20171012 Page 8 Type 3 - Vehicle Wiring Reference Chart Wire Information Connector Information Function Color Polarity Location Color Pins Volkswagen Golf Alltrack (Smart Key) 2017 HS CAN 1 High Orange/Red Data OBDII. Black HS CAN 1 Low...
  • Page 9: Firmware: Vw06 Rev

    Platform: DBALL2 Firmware: VW06 Rev.: 20171012 Page 9 Locating Components in the vehicle ESCLCM - Electronic Steering Column Lock Control Module at Steering Column VESCM - Vehicle Electrical System Control Module at Driver Side under dash, above Driver Kick Panel...
  • Page 10: Immobilizer Interface With Oem Immob. Receiver

    Platform: DBALL2 Firmware: VW06 Rev.: 20171012 Page 10 Method 1: Immobilizer interface with OEM Immob. Receiver Push-To-Start (PTS) Common Relay 2: Yellow/Red: 11 NO Relay 2: Brown/Red: 12 4-6 loops Immobilizer Receiver DBALL2 Prog. Button Remove battery from OEM Remote Control...
  • Page 11 Platform: DBALL2 Firmware: VW06 Rev.: 20171012 Page 11 Method 3: Key wrap for Push-to-Start (PTS) using OEM Immobilizer Ring. Push-To-Start (PTS) NC Relay 2: Orange/Red: 10 Common Relay 2: Yellow/Red: 11 NO Relay 2: Brown/Red: 12 4-6 loops DBALL2 Prog. Button...
  • Page 12: Module Programming

    Platform: DBALL2 Firmware: VW06 Rev.: 20171012 Page 12 Module Programming Refer to the LED Diagnostics section on pages 15-16 for more information and for troubleshooting purposes. Important Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to ensure everything is correct prior to moving onto the next step.
  • Page 13: Module Reset

    Platform: DBALL2 Firmware: VW06 Rev.: 20171012 Page 13 Module Reset A module reset will only erase programming performed in the previous steps. All settings (firmware) and settings flashed to the module using the web config tool will not be affected.
  • Page 14: Feature & Option List

    Platform: DBALL2 Firmware: VW06 Rev.: 20171012 Page 14 Feature & Option List It is recommended to configure all the features and options listed below using the configuration tool found on the module flashing page on www.directechs.com. The web offers more options; however, manual configuration of the features is possible using the information on this page.
  • Page 15: Led Diagnostics & Troubleshooting

    Platform: DBALL2 Firmware: VW06 Rev.: 20171012 Page 15 LED Diagnostics & Troubleshooting Description Troubleshooting Module Programming Make sure the D2D harness is connected or that the 12 Module has no power. Volt is present between the red and black wires. If the 12 Volt is present, the module may be defective.
  • Page 16 Platform: DBALL2 Firmware: VW06 Rev.: 20171012 Page 16 Description Troubleshooting If programming BCM still fails after making sure doors Flashes red Skip programming. are unlocked press on the reset button 5 times to skip x 11 this step. Failed to program the BCM. Check if doors are locked. If Flashes red BCM programming.
  • Page 17: Limited One-Year Consumer Warranty

    Platform: DBALL2 Firmware: VW06 Rev.: 20171012 Page 17 Limited One Year Consumer Warranty For a period of ONE YEAR from the date of purchase of a Directed Electronics remote start or security product, Directed Electronics. (“DIRECTED”) promises to the original purchaser, to repair or replace with a comparable reconditioned piece, the security or remote start accessory piece (hereinafter the “Part”), which proves to be defective in workmanship or material...
  • Page 18: Quick Reference Guide

    Quick Reference Guide DBALL2-VW06 Vehicle Takeover with Get In and Go* Pit Stop Mode The Pit Stop Mode feature is practical when you need to stop and run an errand, Close the vehicle doors, hood and trunk, then press but wish to keep the engine running.
  • Page 19 Quick Reference Guide DBALL2-VW06 List of Available Commands Notes Note that the information below is for Viper, Clifford and Python models. Icons and commands may differ depending on the remote brand and model purchased. Refer to your authorized installation center for more information.

Table of Contents