Quick Reference Guide - Xpresskit DBALL2 Installation Manual

Quick Reference Guide

DBALL2-FORD6 Remote Start Ready (RSR) Installation
Vehicle Takeover
Enter the vehicle, insert the key into the ignition
1
barrel and turn it to the ON or IGN position.
Press the brake pedal, put the car
2
in gear and drive off.
Pit Stop Mode
The Pit Stop Mode feature is practical when you need to stop and run an errand,
but wish to keep the engine running.
Stop the vehicle in a safe parking spot
1
and put the gear in Park (P).
Press the remote start button on the
aftermarket transmitter*.
2
The parking lights will flash once to
indicate the vehicle is now in Pit Stop Mode.
Turn the key to the OFF position and remove it
from the ignition barrel. It is now safe to leave
3
the engine running and exit the vehicle.
Note: We recommend that you always lock the
doors of your vehicle when leaving it unattended.
* Your aftermarket remote may differ from the model shown in the illustrations.
Key IN
START
Ready to
drive off
P
&
Stop & put vehicle in Park (P)
Press
Remote
Start
Key OUT
START
Parking Light Error Codes
The parking lights on your vehicle will flash a specific number of times 3 seconds
following an unscheduled shutdown or failure to start. Each flashing pattern is
described below.
Flashes Diagnostic
1 Runtime expired.
2 Over-rev shutdown.
3 Low/No RPM.
4 Transmitter shutdown.
5 Brake shutdown.
6 Hood shutdown/Remote start safety override switch is ON*.
7 Remote start safety override switch is ON*.
* If the vehicle hood status is supported through data, safety override switch input
will report 7 flashes.
Remote Start Ready (RSR)
Remote Start Ready (RSR) is a function that enables the interface
module to remote start the vehicle completely on its own.
Consequently, there is no need for an aftermarket or an OEM remote
starter in order to start the vehicle from a distance.
3x OEM Lock Remote Start Activation
This solution includes the option to remote start your vehicle by pressing the Lock
button 3 times consecutively. If your vehicle allows the OEM remote to remain
active while the engine is running, you may shut down your remote starter by
pressing the Lock button 3 times once more.
Note: The range offered by OEM remotes is limited and typically requires you to be
within eyesight of the vehicle to control it.
© 2017 Directed. All rights reserved.