Page 2
Bouton de CONNECTOR Programmation CHALL web resources: www.xpresskit.com www.directechs.com Before proceeding with the installation refer to the vehicle fit guide to determine which T-harness is required. Avant de procéder avec l'installation, référez-vous au Guide des Véhicules pour déterminer lequel des Harnais en T est requis.
Page 3
Routan *Sliding Door in D2D mode only *Porte couilissante en mode D2D seulement **See note on the configuration **Voir la note dans la configuration www : Visit www.xpresskit.com to download an installation guide for this specific vehicle. Visitez le www.xpresskit.com pour télécharger un guide d'installation spécifique à...
Page 4
CHALL REMOTE CAR STARTERS AND ALARM INTERFACE CONNECTION GO PROGRAM: 1 CHTH1 WITH D2D \ AVEC D2D OUTPUT | SORTIE INPUT | ENTRÉE wire-to-wire Always connect Toujours branché 1-way Only connect for 1-Way D2D Remote Starter or Alarm PORT Branchez pour D2D 1-voie seulement Démarreur ou alarme Yellow/Black | Jaune/Noir n.c.
Page 5
CHALL REMOTE CAR STARTERS AND ALARM INTERFACE CONNECTION GO PROGRAM: 1 CHTH1 WITHOUT D2D \ SANS D2D OUTPUT | SORTIE INPUT | ENTRÉE Remote Starter or Alarm Démarreur ou alarme CONN. 2 Yellow/Black | Jaune/Noir Trunk | Valise Purple/White | Mauve/Blanc Unlock | Déverrouillage Orange/Black | Org/Noir E-Brake Status...
Page 6
CHALL REMOTE CAR STARTERS AND ALARM INTERFACE CONNECTION GO PROGRAM: 1 CHTH2 WITH D2D \ AVEC D2D WITH DATA-LINK OUTPUT | SORTIE INPUT | ENTRÉE Dodge Dakota 2005-2006 - Dodge Durango 2004-2006 Ign.1, Ign.2, Acc.1, Acc.2, Start1 & Key Sense wires from the vehicle ignition main harness must be connected to the remote-starter.
Page 7
CHALL REMOTE CAR STARTERS AND ALARM INTERFACE CONNECTION GO PROGRAM: 1 CHTH2 WITHOUT D2D \ SANS D2D Remote Starter or Alarm | Démarreur ou alarme OUTPUT | SORTIE INPUT | ENTRÉE Dodge Dakota 2005-2006 - Dodge Durango 2004-2006 Ign.1, Ign.2, Acc.1, Acc.2, Start1 & Key Sense wires from the vehicle ignition main harness must be connected to the remote-starter.
Page 8
CHALL REMOTE CAR STARTERS AND ALARM INTERFACE CONNECTION GO PROGRAM: 2 CHTH2 WITH D2D \ AVEC D2D WITH DATA-LINK WITH DATA-LINK OUTPUT | SORTIE OUTPUT | SORTIE INPUT | ENTRÉE INPUT | ENTRÉE Starter (+) (+) Ignition 2 (-) While running 1-way Only connect for 1-Way D2D Remote Starter or Alarm...
Page 9
CHALL REMOTE CAR STARTERS AND ALARM INTERFACE CONNECTION GO PROGRAM: 2 CHTH2 WITHOUT D2D \ SANS D2D OUTPUT | SORTIE OUTPUT | SORTIE INPUT | ENTRÉE INPUT | ENTRÉE Starter (+) (+) Ignition 2 (-) While running Remote Starter or Alarm Démarreur ou alarme Yellow/Black | Jaune/Noir Trunk | Valise...
Page 10
CHALL REMOTE CAR STARTERS AND ALARM INTERFACE PROGRAMMING | PROGRAMMATION Vehicles with OEM alarm Véhicule avec alarme d'origine Or | Ou Purple/White Flash 1 sec. The Red Insert Insert the 4 pin Turn the The Red LED Press the unlock Ground the LED is button on the...
Page 11
CHALL REMOTE CAR STARTERS AND ALARM INTERFACE PROGRAMMING | PROGRAMMATION Vehicles with OEM alarm Véhicule avec alarme d'origine Or | Ou Purple/White Flash 1 sec. The Red Insert Insert the 4 pin Turn the The Red LED Press the unlock Ground the LED is button on the...
CHALL REMOTE CAR STARTERS AND ALARM INTERFACE LIMITED ONE-YEAR CONSUMER WARRANTY For a period of ONE YEAR from the date of purchase of a Directed Electronics remote start or security product, Directed Electronics. (“DIRECTED”) promises to the original purchaser, to repair or replace with a comparable reconditioned piece, the security or remote start accessory piece (hereinafter the “Part”), which proves to be defective in workmanship or material under normal use, provided the following conditions are met: the Part was purchased from an authorized DIRECTED...