Spdif Out From Speaker; Aux Outputs From Inputs 1-4 (And Daw) - Arturia AUDIOFUSE STUDIO User Manual

1.4.12. SPDIF Out from Speaker

By default, AudioFuse Studio's SPDIF output carries its own signal and is independent of the
other outputs. However, AudioFuse Studio has the ability to set its SPDIF output to mirror
the main speaker output after the master volume control knob. This is an extremely useful
feature if you are using an external digital to analog converter or certain speakers that
have SPDIF inputs. This can be set in the AudioFuse Control Center application. Refer to that
product's documentation [p.45]

1.4.13. AUX outputs from Inputs 1-4 (and DAW)

It is possible to route a variety of sources to the AUX outputs of AudioFuse Studio: Main mix,
Cue 1, Cue 2, the direct output of your DAW and the direct input on channels 1-4. This is very
useful as it allows you to record a live guitar "direct" through the AudioFuse instrument input
while simultaneously sending the live analog signal off to a guitar amplifier that you can
also record separately. This is something that can normally be done only with a costly DI
box with a splitter.
Having the ability to do this means you can capture the sound of the guitar amp "as played"
but also have a backup DI recording available in case you decide that you would like a
different guitar tone. In this case, you can re-amp the DI recording using the instructions
described earlier in this chapter.
Arturia - User Manual AudioFuse Studio - AudioFuse Studio
to learn more.
25