Homematic IP HmIP-DRDI3 Installation And Operating Manual page 55

To integrate the device into your system and to enable
control via the free Homematic IP app, you must teach-in
the device to your Homematic IP Access Point first.
To teach-in the device, please proceed as follows:
• Open the Homematic IP app on your smartphone.
Select the menu item "Teach-in device".
•
• After power supply is established, the teach-in
mode will be active for 3 minutes.
You can manually start the teach-in mode for
another 3 minutes by pressing the system button
(A) briefly (see figure 9).
• Your device will automatically appear in the
Homematic IP app.
• To confirm, enter the last four digits of the device
number (SGTIN) in your app or scan the QR code.
Therefore, see the sticker supplied or attached to
the device.
• Wait until the connection is completed.
• If connecting was successful, the LED (A) lights
up green. The device is now ready for use.
• If the LED lights up red, please try again.
• Select the desired solution for your device.
• In the app, give the device a name and allocate
it to a room.
Start-up
55