Table of Contents
Advertisement
Safety Warnings
Danger
Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
1040
Danger
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Warning
Read the installation instructions before you connect the system to its power source. Statement 1004
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
1040
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
To comply with the Class A emissions requirements shielded twisted pair T1/E1 cables must be used for
SPA-8-Port Channelized T1/E1 SPA (SPA-8XCHT1/E1) on the router. EN55022/CISPR22 Statement
Warning
To comply with Class A emissions requirements- shielded management Ethernet, CON, and AUX cables on
the router must be used.
Warning
Power cable and AC adapter - When installing the product, please use the provided or designated connection
cables/power cables/AC adaptors. Using any other cables or adapters could cause a malfunction or a fire.
Electrical Appliance and Material Safety Law prohibits the use of certified cables (that have the 'UL' shown
on the code) for any other electrical devices than products designated by Cisco. The use of cables that are
certified by Electrical Appliance and Material Safety Law (that have 'PSE' shown on the code) is not limited
to Cisco-designated products. Statement 371
Warning
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than: AC power supplies for the Cisco 4451-X ISR. Statement 1005
Cisco 5400 Enterprise Network Compute System Hardware Installation Guide
4
Overview of the Cisco 5400 Enterprise Network Compute System
Advertisement
Table of Contents
