Minelab MDS-10 Operation Manual page 63

Dual sensor detector
Table of Contents

Advertisement

Hazard
Precaution
The MDS‑10 comes with a high capacity, rechargeable lithium‑ion battery. Both the
battery and MDS‑10 provide internal protection circuitry to ensure safe operation
of the battery. All local regulations related to the operation, handling, storage and
transportation of lithium‑ion batteries must be observed, including the following:
• Inspect lithium‑ion batteries before use. Do not use batteries with the equipment if
• Do not short circuit or reverse polarity the lithium‑ion batteries. Fire or explosion
• When fitting batteries to the detector, ensure the O‑ring on the battery around the
• Do not use or store the lithium‑ion batteries outside the specified operating
• Do not recharge the lithium‑ion batteries with anything other than the battery
Lithium‑ion battery
• Do not allow the lithium‑ion battery internal cells to fully discharge. (Note: batteries
safety and advice
• Ensure batteries have at least a partial charge if prolonged storage is anticipated.
• Do not expose lithium‑ion batteries to fire, explosion, solvents or corrosives or
• Do not incinerate, puncture, crush, or otherwise damage or misuse lithium‑ion
• Do not transport lithium‑ion batteries by aircraft except where explicitly authorised
• Dispose of lithium‑ion Batteries only in accordance with all applicable local and
• Recharge the battery after long periods of non‑use to maximise battery life
The charger has been constructed from quality materials and is designed to be
maintenance‑free.
• Do not attempt to charge batteries other than the Harris 12041‑2400 series
Battery charger
• Do not substitute the AC power supply supplied with battery charger for any other
safety
• Do not attempt to charge batteries outside of the recommended charging
• Do not block the ventilation slots.
• Keep away from moisture. Clean only with a dry or slightly damp lint‑free cloth.
• Do not remove cover. The charger has no internal user‑serviceable parts.
damaged in any way.
may result.
contacts is fitted to prevent moisture, sand or dust fouling the battery contacts.
temperature range for the Detector.
charger supplied with the equipment.
may be safely operated until the MDS-10 shuts down due to low battery, without fully
discharging the battery internal cells.)
other hazardous substances.
batteries.
under applicable air transport regulations. Observe all applicable regulations when
transporting the equipment.
national environmental regulations.
(approximately every 6 months)
batteries supplied with the MDS‑10 using the supplied charger. Attempting to
charge a battery with the wrong chemistry can result in an incomplete charge,
battery damage, fire or explosion.
AC power supply.
temperature range of 0°C to +40°C (+32°F to +104°F).
Troubleshooting, Safety, and Maintenance | 63

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents