Table of Contents
Advertisement
Extend the Middle Shaft
11. Open the upper shaft camlock.
12. Extend the middle shaft.
13. Close the upper shaft camlock.
Attach Battery
14. Align the battery perpendicular to
its final position.
15. Depress the Battery Lock Lever.
16. Rotate the battery 90 degrees,
then release the lever.
Once the detector is unfolded, proceed to Quick Start on page 20.
MDS‑10 Folding Procedure
Repeat the Unfolding procedure steps in reverse.
Note: The MDS‑10 can be stowed with the Li‑ion
battery attached. The battery slides into the
cavity inside the Sensor Head when the lower
shaft is collapsed.
180° Sensor Head Rotation
The MDS‑10 Sensor Head can be rotated 90° to
both the left and right for detecting on angled
surfaces such as the side of a trench.
1. Open the Sensor Head rotation camlock.
2. Rotate to the Sensor Head preferred position.
3. Close the camlock.
11
16
The Lithium-ion battery inside the Sensor Head.
1
3
12
13
14
2
Getting Started | 13
15
Hide quick links:
Advertisement
Table of Contents
