Table of Contents
Advertisement
Detector Audio
The MDS‑10 is compatible with a number of Audio accessories.
Volume
The MDS‑10 has a single Volume control adjusting
MD, GPR and user interface audio responses.
The Volume setting has a range from 1 to 10 with a
default setting of 6.
Adjusting the Volume
1. From the Detect Screen, short‑press either the
Plus (+) or the Minus (–) button to display the
Volume adjustment bar.
2. Short‑press the Plus (+) or Minus (–) buttons to
increase or decrease the Volume level.
The Volume adjustment bar will disappear
after 3 seconds of inactivity.
Audio Output Modes
MDS‑10 has 3 Audio Output Modes:
Speaker Auto‑Mute (Default)
Speaker and Earset On
Speaker Off
Speaker Auto‑Mute (Default)
Speaker audio is automatically On if an
earset is not connected. Speaker audio is
automatically muted (Off ) if an earset is connected.
Speaker and Earset On
Both the Speaker and the earset are On.
This is a useful mode for training scenarios.
Speaker Off
Speaker audio is always Off, even if there is
no earset connected.
Note: Speaker Off mode overrides the MD and
GPR enabled audio settings.
Selecting the Audio Output Mode
1. Short‑press the Setup button to display the
Setup Screen. The General Setup Page Soft Key
Options will be displayed along the bottom of
the screen.
2. Short‑press the Plus (+) button (directly below
the Audio Output icon). The Audio Output
Mode icon will change to the next Mode.
Each short‑press of the Plus (+) button will
select the next Audio Output Mode.
3. Short‑press the Setup button to return to the
Detect Screen.
Settings Adjustment | 27
Hide quick links:
Advertisement
Table of Contents
