Table of Contents
Advertisement
MDS‑10 Unfolding Procedure
Follow these steps to unfold the MDS‑10 ready for operation.
Before beginning, remove the detector from the protective hard‑case or carry bag.
Extend the Lower Shaft
1. Open the lower shaft camlock.
2. Slide the lower shaft out to full
extension.
3. Close the lower shaft camlock.
Unfold the Detector
4. Open the lateral shaft camlock.
5. Holding the control box, rotate the
Sensor Head and shafts around
180° until the end stop is reached.
The handle will follow the shafts.
6. Close the lateral shaft camlock.
Unfold the Sensor Head
7. Pivot the Sensor Head out. The
Sensor Head should be parallel
to the ground when held in the
detecting position.
8. If required, tighten the tension nut
so that the Sensor Head holds its
angled position.
Position the Armrest
9. Squeeze the finger grips on the
rear of the armrest to release the
locking mechanism.
10. Slide to a comfortable position.
12 | Getting Started
1
8
10
2
3
5
4
6
9
7
Hide quick links:
Advertisement
Table of Contents
