Sensor Feedback Settings; Selecting Sensor Feedback Settings - Minelab MDS-10 Operation Manual

Sensor Feedback Settings

Sensor Feedback upon target detection is provided via a combination of
visual, audio, and tactile (vibration) responses. These combinations can be
selected to suit the detecting application and user preference.
The visual, audio, and tactile (vibration) Feedback
Settings for each sensor can be independently
enabled and disabled via the Setup Screen.
For information on the parts of the Setup Screen
and the Setup Pages (General, MD, and GPR), read
Setup Screen on page 18.
All Feedback Settings for the MD and GPR Sensors are
On by default.
It is recommended that audio feedback for both
sensors is enabled, as it is capable of conveying
more detection signal information than visual
or vibration feedback alone. Visual and vibration
feedback is best used to supplement audio.
MD GPR Feedback Setting
Visual (LED) Feedback Setting
Audio Feedback Setting
Vibration Feedback Setting
Selecting Sensor Feedback
Settings
1. Short‑press the Setup button to open the
Setup Screen. The General Setup Page options
are displayed by default on the Setup Screen.
The Setup button
2. To display the MD Setup Page, short‑press the
MD button (shown in example)
The MD button
Or, to display the GPR Setup Page, short‑press
the GPR button.
The GPR button
The Feedback Settings are displayed as icons
(Soft Key Options) along the bottom of the
screen.
3. Short‑press the button directly below the
Feedback Setting icon to enable/disable it.
Enabled
The MD Setup Page showing the Visual and Vibration
settings disabled.
Note: At least one Feedback Setting must and
will always be enabled.
4. When the selections have been made, short‑
press the MD button to return to the General
Setup Page, or short‑press the Setup button to
return to the Detect Screen.
Settings Adjustment | 25
Disabled