Md Error Codes; Gpr Error Codes - Minelab MDS-10 Operation Manual

MD Error Codes

MD Error Codes indicate a possible fault with the
MD coil or MD coil cable in the Sensor Head, or
the MD electronics in the control box.
If an MD fault occurs, the error icon will appear
on the Detect Screen, adjacent to the MD Sensor
Feedback icons on the left.
The Error Code corresponding to the fault will be
displayed on the left of the Setup Screen.
MD Coil Error Recommended Action:
1. Disable/enable MD Sensor.
2. Turn the detector Off and then On again.
3. Perform Factory Reset (page 61).
If the fault persists, return the detector to an
Authorised Service Centre.
Code Fault
Control box incompatible
M01
error
M02 Control box comms fault error Critical
M03
MD Tx fault
M04
MD Rx fault
M05
MD VTX out of range
M06
MD A4V out of range
M07
Coil auth failure
M08
Control box auth failure
M09
Coil calibration load failure
Control box calibration load
M10
failure
Control box temperature
M11
sensor 1 over range
Control box temperature
M12
sensor 1 under range
Control box temperature
M13
sensor 2 over range
Control box temperature
M14
sensor 2 under range
60 | Troubleshooting, Safety, and Maintenance

GPR Error Codes

GPR Error Codes indicate a possible fault with the
GPR Sensor.
If a GPR fault occurs, the Error icon will appear on
the Detect Screen, adjacent to the GPR Sensor
Feedback icons on the right.
The Error Code corresponding to the fault will be
displayed on the right of the Setup Screen.
GPR Error Recommended Action:
1. Disable/Enable GPR Sensor.
2. Perform Skyshot.
3. Turn the detector Off and then On again.
4. Perform Factory Reset (page 61).
If the fault persists, return the detector to an
Authorised Service Centre.
Severity Code Fault
G01
Critical
G02
G03
Critical
G04
Critical
G05
Critical
G06
Critical
G07
Critical
G08
Critical
G09
Critical
G10
Critical
G12
G13
Advisory
G14
Advisory
G27
Advisory
Advisory
GPR incompatible error
GPR comms fault error
GPR DSP code load fault
GPR FPGA code load fault
GPR DSP start‑up fault
GPR Skyshot fault
GPR HV calibration fault
GPR trigger table load fault
GPR DCP peaks invalid fault
GPR scan rate fault
GPR MEMS fault
GPR frame gap warning
GPR DCP peak warning
GPR option ROM not
accessible
Severity
Critical
Critical
Critical
Critical
Critical
Critical
Critical
Critical
Critical
Critical
Advisory
Advisory
Advisory
Advisory