Summary of Contents for Smith & Noble Metro Track Flat Wood Hardware
Page 1
STEP BY STEP INSTALLATION INSTRUCTIONS Metro Track Flat Wood Hardware Warranty Service The enjoyment of your hardware should be everlasting, which is why our products come with a limited lifetime warranty. The warranty applies to the original owner, requires a proof of purchase (hang on to your receipt!) and covers defects in material or craftsmanship.
STEP 1 - GETTING STARTED OVERVIEW Tools & Parts Wall Mount Double Return Rod Set Before you begin, check the accompanying diagram to make sure you have all the parts you need. You’ll need to make sure the surface you intend to install your hardware is sturdy enough to accommodate the brackets.
STEP 2 - MOUNTING BRACKETS STEP 2 - MOUNTING BRACKETS Mounting the Brackets Mounting the Brackets FIGURE A Place the panel on the rod. To Place center of bracket cover plate ensure it drapes at the correct level against wall at the marked length, hold it up to the spot you spots.
STEP 3 - ATTACHING THE ROD CONNECTOR STEP 4 - ADDING OR REMOVING CARRIERS Front Rod Depending on your order, you may Your track rod will come with all master CARRIERS ROD CONNECTOR have received a rod connector. carriers and regular carriers pre-installed. If you need to add or take out some A rod connector is the short piece of CORNER...
Page 6
STEP 4 - ADDING OR REMOVING CARRIERS STEP 4 - ADDING OR REMOVING CARRIERS MASTER CARRIERS FRONT FRONT ROD Back Rod Back Rod CARRIER FINIAL SPLIT DRAPERY (A) Your track rod will come with all master carriers and regular carriers pre-installed. Once all carriers have been placed in the If you need to add or take out some track, for split drapery, place end stop in...
STEP 5 - ATTACHING BRACKET POSTS STEP 7 - ATTACHING BACK ROD CLIPS MOUNTING Insert the mounting posts into the POST CHANNEL 1. Assemble Back Rod Clips for Outside Posts. channel in the back of the track. Do not tighten at this time. Attach End Cap Finial.
STEP 9 - ATTACHING BACK ROD STEP 8 - ATTACHING BRACKET POSTS TO BRACKET BASES MOUNTING POST Place the front lip of the track into the front Attaching Bracket Posts to edge of the clip. Bracket Bases BACK PLATE Rotate the back of the track up into the Align the mounting posts in the back clips and snap of the track with the brackets mount-...
STEP 10 - ATTACHING DRAPERY TO ROD ACCESSORIES Baton/Wand (optional) Insert drapery pin hooks into carriers and master carriers. Baton/Wand will be pre-attached to Split Drapery the master carrier(s). MASTER DRAPERY For Split drapery, start pining from CARRIER PINS CARRIERS the center and go towards the ends.
CARE & CLEANING NOTES Minimal care and cleaning is needed to maintain the beauty of your Hardware. To Vacuum: Use brush or dust head attachment. To Dust: Use soft, clean cloth. smithandnoble.com 800.248.8888...
Need help?
Do you have a question about the Metro Track Flat Wood Hardware and is the answer not in the manual?
Questions and answers