Overview Of Operations Of The Equipment - JRC JHS-800S Instruction Manual

Operation

4.1 Overview of operations of the equipment

Operations are basically done by using the buttons on the touchscreen. The following is an
overview of their operation.
When two or more controllers are connected, basically only the main unit or controller that has
●
the access rights can be operated, except for sending a distress alert, changing audio volume,
and changing display conditions. (Unless otherwise mentioned, the instructions below are for
the controller with the access right.)
You can obtain the access right at a main unit or controller that does not have access rights by
●
taking the handset off-hook, unless the other main unit or controller is being used (off-hook,
PTT ON, or menus are being operated). However, the device with higher priority can always
obtain the access right unless the lower priority device is in a PTT ON state.
The DISTRESS button is always enabled regardless of the access right (it always has the
●
highest priority). In the status display, you can change the transmitting channel by using the
numeric keypad that is displayed by touching the channel display or the [Select Channel]
button.
Touch the [FUNC]→[CH MONI] buttons on the status display to open Channel Monitor mode.
●
You can force the squelch to open, until the [ CH MONI] button is touched again, so you can
monitor the incoming audio (or noise) regardless of the radio wave reception cond itions.
Replacing the handset on -hook returns the channel to CH16 (factory default value). Also,
●
on-hook detection can be disabled by using the handset menu.
All the functions can be operated by using the [MENU] button on the status display on the
●
touchscreen, as well as the other knobs and buttons. (See the men u tree of the equipment on
the next page.)
In the status display, touching the [FUNC] button displays the buttons with functions that have
●
been registered in advance, so you can easily execute the various registered functions with
simple procedures.
After displaying the main menu by touching the [MENU] button, the items in the main menu are
●
displayed by touching the various buttons.
Any menu can be assigned to the [FAVORITE] button to quickly open it with a single touch of a
●
button.
Touching the [←] button in any menu moves
●
the status display).
Touching the [MAIN] button in any menu moves the display to the status display.
●
If left without operating after opening a menu screen for a while (the time length is variable),
●
the screen automatically returns to the status display.
Dialog boxes (pop-up screens) are opened when necessary and operations can be done in the
●
dialog box.
Items in the menu tree on the following page indicated by "OK " in the "Printable" column can
●
be printed from a printer connected to the main unit by touching the guidance button (blue) in
any menu screen. (*Printing cannot be done from a controller.)
4-2
the display up one level in the hierarchy (or to