Basic Communication Procedure; Turning On The Power - JRC JHS-800S Instruction Manual

Operation

4.2 Basic communication procedure

The following describes basic radio communication procedures.
4.2.1

Turning ON the power

Do NOT turn off the power of the equipment when at sea because the SOLAS
Convention requires keeping CH16 watch at all times.
■ ■
Procedure
1 1 . .
1 .
Press the [PWR] button for at least 1
second.
An operational check is done to the main unit and
controllers. (The screen at right shows the case of the
main unit.) If it ends successfully, the status display
appears and the channel that appears on screen is
receiving.
- If detected errors during the memory
Note
check, displays the message below.
Please inform JRC or our agent of the
error contents.
- Pressing the [PWR] button for 5 to 10
seconds or more will completely turn
off the power. When you press for 2
seconds or longer, the pop -up "THE
SYSTEM WILL BE SHUT DOWN
WITHIN 8 SECONDS." will be
displayed.
DETECTED MEMORY ERRO R!
SO CLEARED THE AREA OF VHF RADIOTELEPHONE
MEMORY.
DETECTED MEMORY ERRO R!
SO CLEARED THE AREA OF CONTROLLER MEMORY.
DETECTED THIS CONTROLLER'S ADDRESS SETTING
ERROR!
SO REQUIRED INITIAL SET AFTER RESTARTING AS
THE MAINTENANCE MODE
DETECTED JHS-800S LOST!
SO REQUIRED INITIAL SE T AFTER RESTARTING A S
THE MAINTENANCE MODE .
DETECTED MMSI LOST!
SO CONCERNED FUNCTIO NS (DSC/ATIS) NO
LONGER AVAILABLE NOW.
DETECTED THE VHF RADIOTELEPHONE'S PCB
COMBINATION ERROR!
SO REQUIRED TO REPLA CE THAT INCORRECT PC B
WITH THE CORRECT ONE.
4-4
CAUTION
Message Contents
Detected memory error in main unit.
Detected a memory error when starting
controller.
Detected this controller's address error when
starting the controller.
Detected a transmission error between main unit
and controller when starting.
Unregistered MMSI yet, or lost the MMSI. So
required to install MMSI for DSC/ATIS.
Detected improper PCB assembly in main unit.